Hand Markers and Components
Lectroetch Marking Appliances
combine stencil, electrolyte, and marking
current at the part surface. Various styles
of manual markers pen-nit a wide choice
of bench and hand-held appliance parts
marking approaches. Round, flat, and
recessedshaped parts all can be
production marked with these appliances. Most
markers permit use of either short-run Die
Impression or 3L Long Life Stencils.
CH
Replacement cartridge holder for all
Lectroetch 3L cartridge markers and  cartridge hand pads except the 1525.
Cartridge Hand Pads
 Click Here For Part Specifications
 Cartridge Open Hand Pads
The Cartridge Open Hand Pad
employs a reservoir bottle which meters
electrolyte and facilitates longer marking
runs by eliminating interruptions to fluid
supply.
Click Here For Part Specifications
DEP (Deep Etch) Hand Pads
The DEP Hand Pad uses an open
"bridge" to dissipate gas bubbles generated
by electrolysis during marking. This
provides highest quality marks while
extending stencil life. Available in other
sizes for special applications.
Click Here For Part Specifications
Cartridge Markers
Cartridge markers are convenient
for inspection marking, date coding, and
parts numbering on a production basis  because they employ molded 3L Stencils
with factoryprocessed marks. Capable of
thousands of marks, worn stencils are
replaced by Slipping a new stencil over
the marker nose.
CM units include cartridge nose
assembly with Button Stencil and
Cartridge Holder which also contains the
shielded conductor for current flow to the
nose piece.
When ordering, specify if the
complete cartridge marker (CM) or
button stencil only (BSO) is desired.
Click Here For Part Specifications
Saddle Markers
Saddle Markers are designed to
mark cylindrical parts on which the mark
encompasses about 120' or less of the
circumference. The side arms flex and
the pad and stencil form themselves
around the part. This produces a sharp,
clear mark, and is easier and more
accurate than rolling a part across a flat
surface. Used as a hand marker, the
Saddle Marker (left) can be placed on
large parts to eliminate parts "handling."
Stencils are retained by plastic clips on
standard saddle markers.
Click Here For Part Specifications
Rocker Pads
The Rocker Pad is designed for
large, broadline marks. It is rocked across
the part so that current is concentrated in
a small area during the progressive mark
formation, permitting use of a smaller-size
power unit. Because it squeezes out gas
pockets and pushes them ahead, it
minimizes mark imperfections caused by
gas trapped between part and stencil.
Click Here For Part Specifications
Special Markers
Includes concave, convex, radiused and
stepped-call the factory or nearest distributor
with your special marking needs. |
